FIMCO Filter Housing

This is an STL for the FIMCO Pull Behind Sprayer (unsure of model). This part replaces the clear plastic housing that goes before the pump intake and holds the filter screen. This part can not be sourced on-line. Trust me I've scoured the interwebs for it!

I've also included the STL for the O-Ring to be printed using NinjaFlex or equivalent. I was able to source a new O-Ring at a local hardware store.

I've tested this and installed it and it works perfectly in ABS. I did have a slight issue with the small end u-clip. They may be a bit tight and I would suggest test fitting them and possibly drilling them out a bit larger if needed.

Use a brim setting with small opening down and it should print without any supports.

Use ABS for chemical resistance