Finger Guard

This is a finger guard/splint. Meant to stop your finger from bumping into things and aggravating a cut etc....
It's on the large side, 25mm inside diameter, and short - made to fit my husband's thumb.
1mm wall thickness - so you may want to re-size in tinkercad rather than before printing.
pieces are grouped, essentially ungroup the main piece until you get the two cylinders and re-size them to what you need, center align and group them again and voila...

I printed it upside down (that's why the tip is flattened) on my anet A8, cura draft setting with 100% infill. came out alright, if not too pretty.

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/ghqR4YTSDIY