Finger Saver

I made this to fit over the props of my Quadrysteria Rush 4" racing quad. Every time I pick it up with the battery plugged in I feel like I am picking up a human blender. This contraption will capture the props, should they start to spin.

I have not printed this yet. I am throwing it out there as a concept design. Hopefully it will save some fingers. Future edits might include removing angles > 45 degrees to eliminate the need for supports in the few areas that could currently benefit from them.

**Note: The Rush is not a symmetrical frame. The back motors are closer together than the front motors. It is likely that you will have to edit the pod spacing to fit your application. I made it for 4x4.5 bullnose racing props.