Finger Scooter

Okay, so this was probably the most painful one to make in the series and I may wind up doing another one later on as there are a couple of things I would like to revisit, but this scooter works. May come up with new wheels though because those don't have much traction imo. This is a multi-step print, so here we go:The first two steps involve the wheels. On the first plate they will print before the frame fully finishes. These will need to be removed. The first plate is designed to stop at the top of this sectionThis section should have a support blocker preventing supports from being printed there. This is important because one of the wheels will need to be inserted here. I did it like this because this gives the joint a more solid connection. There should be plenty of room for it to drop it and not get fused to the part. The other wheel gets places in the next build plate. This is the same principle but this is meant to be connected to the front of the frame. Beyond that, it'