Thingiverse
Firearm Gift Certificate
por rebeltaz
4
Descargas
20
Likes
0
Makes
When your girlfriend wants a firearm for her Christmas / birthday present but you don't want to buy her something she might not like, you just give her a gift certificate instead. But you don't know how much the gun will cost and you don't know from where she will want it... So, you give her a homemade, generic certificate instead a specific store/amount.
I printed this in two colors, the first two layers green; the middle two layers white; and the last two layers green again. If you are printing at 0.2mm layer heights, that equates to:
* Layer 0 - green
* Layer 2 - white
* Layer 4 - green
For best results, I recommend you enable [Ironing], [Supports] and [Draft Shield], but disable [Z-Hop]. I know from experience that [Z-Hop] just leaves blobs all over the top surface that you'll have to clean up later.
---
**NOTE**
*Due to either a Thingiverse bug or (more likely) shadowbanning, my models no longer show up under the [Newest] listings. If you want to see more of my
I printed this in two colors, the first two layers green; the middle two layers white; and the last two layers green again. If you are printing at 0.2mm layer heights, that equates to:
* Layer 0 - green
* Layer 2 - white
* Layer 4 - green
For best results, I recommend you enable [Ironing], [Supports] and [Draft Shield], but disable [Z-Hop]. I know from experience that [Z-Hop] just leaves blobs all over the top surface that you'll have to clean up later.
---
**NOTE**
*Due to either a Thingiverse bug or (more likely) shadowbanning, my models no longer show up under the [Newest] listings. If you want to see more of my
rebeltaz también publica en
253 modelos adicionales en 3 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!