Firebat T8 Plus Replacement Case

*If you want a version with a 60mm fan in the base, check out my other one in the remixes section :-)*

Note that this should in principle fit anything else with the T8PLUS_V12 2023-06-17 motherboard if not more. There are many other N100 PCs that use this board, I think the T9 Plus *possibly* uses it too, as does the Chatreey mini PC.

-Ventilation added at the top
-Proper CMOS battery holder added at the top
-Removed that stupid middle piece of plastic
-Slightly lower profile
-You can choose your own colour of course :-)

You will need:

-1 print of Box. I printed on an Ender 3 without supports and it came out perfectly, but you may need to enable them if your printer or material doesn't handle bridges and overhangs well. You may wish to consider a brim if your printer or material is prone to warping.
-1 print of Box Underside. No supports needed.
-1 print of Power Button. Depending on how your slicer is set up you may need to enable supports, though I would recom