Thingiverse
Firefly Diffuser lamp
von JEM_3DPrints
40
Downloads
37
Likes
0
Makes
28/02/2021
- V3 base, cleaned up edges to slightly improve printing time and filament usage.
08/02/2021
- V2 base, split into 2 parts (base and pillar) to split printing time.
- V2 Lamp shade, decreased x and y by 1% for better tolerance
Minimalist lamp design with semi-modular components. The entire design can be printed with very few supports, leaving minimal post-processing and easy assembly. The light diffuser is made using vase mode in Cura's slicer settings, and uses standard white PLA. This is my first design, so feedback is appreciated!
Lamp base
the base of the lamp was originally designed to accept a light bulb socket for use with an LED light bulb. Although any standard bulb can work, I used a Meross RGB LED configured to Apple Homekit as a light source. If you are running the light for a long time, I recommend using LED bulbs to avoid damage from heat. The slots on the base friction-fit the rods and lamp shade, so no adhesives are required. A rectangular hol
- V3 base, cleaned up edges to slightly improve printing time and filament usage.
08/02/2021
- V2 base, split into 2 parts (base and pillar) to split printing time.
- V2 Lamp shade, decreased x and y by 1% for better tolerance
Minimalist lamp design with semi-modular components. The entire design can be printed with very few supports, leaving minimal post-processing and easy assembly. The light diffuser is made using vase mode in Cura's slicer settings, and uses standard white PLA. This is my first design, so feedback is appreciated!
Lamp base
the base of the lamp was originally designed to accept a light bulb socket for use with an LED light bulb. Although any standard bulb can work, I used a Meross RGB LED configured to Apple Homekit as a light source. If you are running the light for a long time, I recommend using LED bulbs to avoid damage from heat. The slots on the base friction-fit the rods and lamp shade, so no adhesives are required. A rectangular hol
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
