Slicer Discord
Firefly Shadowbox Light Display – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Firefly Shadowbox Light Display

80 Downloads
77 Likes
31 Makes
Zum Modell
A Firefly/Serenity shadowbox based off of a paper version. This light display uses multiple layers to achieve a 3D, multi-depth look. Printed on Bambu Labs A1 (with AMS, although it is not necessary) and textured PEI plate. Colors used: Elegoo White and Elegoo Black (available on Amazon). 0.4mm nozzle with a 0.2mm layer height. No supports needed. What to print:1 copy of each Asset (1-5)1 copy of Shadowbox Frame1 copy of Shadowbox Frame Back5 copies of Spacer Insert (to go between the layers)1 8in x10in piece of acrylic plastic sheet (or glass) cut to size (available at most hardware stores) - not required but helps keep area between layers clean1 LED tape light strip (available on Amazon or most hardware stores) I used an RGB tape light strip with remote so I can change the colors and brightness. Acrylic plastic can be easily cut to size with a utility knife and straight edge, glass will require oil and a glass cutter. Assembly: 1.) Place the Shadowbox Frame face down on a flat surfac
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Mittlere Konfidenz
Warum?
2 Farben · 0.20mm Schichten
Einteilig 2 Farben / AMS Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS
Farben
2 (AMS/MMU empfohlen)
Schichthöhe
0.2 mm
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen