Slicer Discord
Firestarter FS9-C – 3D-Druckmodell von Thingiverse Thingiverse

Firestarter FS9-C

2 Downloads
2 Likes
0 Makes
Zum Modell
Due to the Firestarter being the only Battlemech the Circinus Federation can produce, the Periphery has a relatively overabundance of the mech. As such, when the FS9-C was first produced, the mech was very nearly a failure. Once the capabilities were realized, the FS9-C was saved from oblivion. As we've picked up a large number at a discount cost, we're offering those savings to you!

The FS9-C is equipped with a Flamer and Medium Laser in each arm, with 2 Rocket Launcher 15's in the right torso, 2 Rocket Launcher 10's in the left torso, and 2 Rocket Launcher 10's in the center torso. The first Mechwarriors to encounter these variants probably did not pay too much attention to their readout displays and assumed the were standard FS9-H's. Imagine their surprise when 15 to 70 rockets shredded their mechs. So we are here to pass that benefit on to you, loyal customer! Enjoy!

Base Firestarter design by Logret on Thingiverse; check them out at (https://www.thingiverse.com/thing:5380894)

L
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen