Thingiverse
First Layer Adhesion Test
von SUP3RN0VA
41
Downloads
64
Likes
0
Makes
This is a 1st layer adhesion test that is 1 layer thick, and should work with any 3d printer if you scale it properly to your bed.
It might be hard to remove from the build plate if your bed is too high
It might be hard to remove from the build plate if your bed is too high
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
