Fischertechnik Customizable Angle Block

This exists to allow you to use the customizer. But if you want to see the full collection of the Fischertechnik angle blocks, look here:
https://www.thingiverse.com/thing:4339870

or here:
https://gitlab.com/MRAAGH/angle-blocks

Usually printing with 1 wall and no infill is fine, but if you want them to handle some load, use 2 walls and 20% infill!

To avoid headaches, you should print these on hot glass, without a brim, without a part cooling fan, no more than 10 pieces at once and with z-hopping enabled.