Thingiverse
Fischertechnik Customizable Angle Block With Knob
door MRAAGH
10
Downloads
3
Likes
0
Makes
This exists to allow you to use the customizer. But if you want to see the full collection of the Fischertechnik angle blocks, look here:
https://www.thingiverse.com/thing:4339870
or here:
https://gitlab.com/MRAAGH/angle-blocks
Usually printing with 1 wall and no infill is fine, but if you want them to handle some load, use 2 walls and 20% infill!
To avoid headaches, you should print these on hot glass, without a brim, without a part cooling fan, no more than 10 pieces at once and with z-hopping enabled.
https://www.thingiverse.com/thing:4339870
or here:
https://gitlab.com/MRAAGH/angle-blocks
Usually printing with 1 wall and no infill is fine, but if you want them to handle some load, use 2 walls and 20% infill!
To avoid headaches, you should print these on hot glass, without a brim, without a part cooling fan, no more than 10 pieces at once and with z-hopping enabled.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
