Slicer Discord
Fish adder – Modelo 3D imprimible de Thingiverse Thingiverse

Fish adder

0 Descargas
0 Likes
0 Makes
Ver Modelo
When placing fish into a tank, it is hard to scoop them out of the bag after floating the bag. I instead like placing t a net over a pitcher, or something, and catching the fish for transfer into the tank. Unfortunately, this doesn't always work. There are times when the net moves, water slops over, etc. I don't like risking it, so I created this. It's nothing to look at, but it works. The side clip easily slides into whatever pitcher you use. I recommend, just in case, having some water in the pitcher before use to help keep it balanced/upright. There is a small rim at the top to help with any sloshing out. The net sits into the two indentations on the side box and a small chip clip can be used to stop it from rolling. It was a happy accident, but the water slowly drains so the fish are not completely left open until you remove the net.
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección