MakerWorld
Other Toys & Games
Go to Model
Fish bubble tube support
14
Downloads
5
Likes
0
Makes
The vertical fish bubble tubes on sale in Argos and the like are prone to toppling over….8 lt of water all over the floor !!!Wall clamps are available but cost nearly as much as the tube itself, didnt think they looked very nice and seemed a phaff to use so I came up with the attached which uses 25m of filament and costs less than £1The ring simply slips over the tube then positively locates on the wall fixing which is spaced to accommodate standard skirting board thicknessI used PETG as thats the filament I use for everything
davidwf also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!