Thingiverse
Fish feeding ring - crown design
door P_Kuehnel
56
Downloads
51
Likes
0
Makes
This is a feeding ring for your aquarium which turns your fish into little Kings or Queens. It fits well for bettas with its inside diameter of 80 mm.
The tips of the crown design allow easy removal after feeding without having to get your hands wet.
It has to be printed in a lightweight fashion, for it to properly swim.
I used the following settings for PLA:
- wall line count: 2
- top and bottom layer: 6
- infill 15%
You can go below those values, I would not recommend going higher.
The tips of the crown design allow easy removal after feeding without having to get your hands wet.
It has to be printed in a lightweight fashion, for it to properly swim.
I used the following settings for PLA:
- wall line count: 2
- top and bottom layer: 6
- infill 15%
You can go below those values, I would not recommend going higher.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!