Thingiverse
Fishing Bobber
door markaerrington
9
Downloads
4
Likes
0
Makes
After seeing and buying the Rocket Fishing Rod from Amazon. I tried to make the bobber and after many times rebuilding it using thinkercad, I think this one will work. I'm still kind of working on it but I think you will enjoy this one. I'm going to try it out sometime this week, maybe, and see how it will launch using my air cannon with a 1 inch pvc pipe, and I'll try the 1.5 inch pipe with my 1.5 inch bobber.
Print the "Top Rocket Fishing Bobber", standing up with no support, using Brim for Build Plate Adhesion.
Print the "Left Rocket Fishing Bobber" and the "Right Rocket Fishing Bobber" with support, using Brim for Build Plate Adhesion.
Print the "Pin Rocket Fishing Bobber" and "Spacer Rocket Fishing Bobber" together, with no support, using Raft for Build Plate Adhesion. The spacer goes in the middle of the two halves with the rod going thru.
To make the bobber float; I used Foam Board Insulation -1 in. x 2 ft. x 4 ft. R-3.85 Insulating Sheathing and cut 2 round pieces t
Print the "Top Rocket Fishing Bobber", standing up with no support, using Brim for Build Plate Adhesion.
Print the "Left Rocket Fishing Bobber" and the "Right Rocket Fishing Bobber" with support, using Brim for Build Plate Adhesion.
Print the "Pin Rocket Fishing Bobber" and "Spacer Rocket Fishing Bobber" together, with no support, using Raft for Build Plate Adhesion. The spacer goes in the middle of the two halves with the rod going thru.
To make the bobber float; I used Foam Board Insulation -1 in. x 2 ft. x 4 ft. R-3.85 Insulating Sheathing and cut 2 round pieces t
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
