Thingiverse
Fishing bobber
von Sistani
7
Downloads
10
Likes
0
Makes
A fishing bobber.
To be printed with zero density and 3 primetersa and 0.2mm hight.
With a small screw driver the two halves can be centred and then glued.
To adjust the position of bobber either a normal stoper or the stoper attached to the bobber can be used.
To be printed with zero density and 3 primetersa and 0.2mm hight.
With a small screw driver the two halves can be centred and then glued.
To adjust the position of bobber either a normal stoper or the stoper attached to the bobber can be used.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!