Fishing line spooling system

*updated*
I changed the tolerance for the clamp (now Clamp_V2) since it became a little too snug.
I also added another knob (Knob_ V2) for those with greasy fingers or other problems ;)

I designed a helper for when you´re about to spool some new line to your favorite fishing reels.
Use 3mm bolts and nuts.
Use two of those fuzzy furniture feet between the clamp and the bottom plate, and then adjust your tension with the screws.

The centerpiece/holder for your fishing line spool are included in 2 versions.
- One is split in half for easier printing (just glue them together)
- One is whole, but perhaps you will be needing some supports for it !

The sides prints in separate pieces and then glued to the bottom plate !

Enjoy !