Thingiverse
Hobby
Ver Modelo
Fishing spooler
814
Descargas
607
Likes
0
Makes
A cheap solution for putting new line to the fishingreel :)
Printed at 30% infill
There is two different versions the small one that i printed and a bigger one for up to 14 cm wide spools.
for the small one you will need 1x m8 nut and bolt and 2x m4 at least 50 mm screws with nuts and the bigger one needs an m8 rod.
If you dont have a 3D-printer check out this one that i printed this thing with,
amazing printer for under 200 USD - https://goo.gl/vxSLFA
Printed at 30% infill
There is two different versions the small one that i printed and a bigger one for up to 14 cm wide spools.
for the small one you will need 1x m8 nut and bolt and 2x m4 at least 50 mm screws with nuts and the bigger one needs an m8 rod.
If you dont have a 3D-printer check out this one that i printed this thing with,
amazing printer for under 200 USD - https://goo.gl/vxSLFA
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
