Fisker Ocean Jack Support Protector

Protectors for somewhat fragile and unobtainable Fisker Ocean plastic jack points.
They fill and brace original support piece to prevent damage.
In addition, 10 mm raise protects rocker panels during lifting.

Two versions are provided:
1. FiskerJackSupportBase.stl - for jack supports partially filled with epoxy
2. FiskerJackSupportFill.stl - for unmodified jack supports

Installation
These pieces can be installed temporarily when needed,
They can also be installed semi-permanently. Fit is pretty tight therefore they should stay in place once pressed in. Little bit of epoxy can be used to glue them in. This should still allow replacement in the future if they get damaged.

Printing instructions
Minimum recommended infill is 50% (more is better).
Recommended material is ASA or PETG. Layer adhesion is important factor here.

Warning:
Use at your own risk!