Fitbit Versa 2 Charging Stand

This project came from seeing a flaw in the charging base for the fitbit versa 2. With the cable coming straight out of the back of the charger(flawed design) it's impossible to charge while lying flat so i designed this stand. The stand prints in 4 parts(clip, base, 2x Legs) and is held together with superglue(what i used).

All parts can be printed without supports(legs may get some zits on first rise but can be sanded down). Also the clip i designed to be slightly wider than the charge base to avoid scratching it. I used the tiniest line of hot glue along the inside of the tabs to create a soft grip for the charge base. Dont use too much hot glue or you will probably end up cracking one of the tabs from too much pressure(i did). I put a small line, squished down a bit the back of my fingernail, let it cool and it worked out fine.