Slicer Discord
Fitbit Versa 3 Cable Management Charging Case – 3D-printbaar model van MakerWorld MakerWorld
Gadgets

Fitbit Versa 3 Cable Management Charging Case

2 Downloads
3 Likes
2 Makes
Model downloaden
This my most refined design so far. The main objective is to eliminate the awkward length of cable that I need to coil before stowing it away. With this, I can just pull this out of the bag pocket and plug it into the charger. The back slides open and the cable entry has a little fillet to protect the wire insulation. Print with whatever settings you're happy with. The tolerance requirements are not very high. I did it with 0.1mm layer height, 2 wall loops. If you arrange it like I did, there's no overhang more than 45 degrees. I didn't upload the .3mf because I reprinted the cover again to reduce the play when it's shut.
Categorie
Gadgets
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
0.10mm lagen
Eendelig
Supports 1/3
Montage 0/3
Instellingen 2/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Laaghoogte
0.1 mm
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie