Five Bearing Mini Spinner
door GearGeek
107
Downloads
68
Likes
4
Makes
After a lot of tweaking and toying around with this design, this is the final.
This uses a 22mm bearing and 4, 1/2 inch steel ball bearings.
For the 1/2 inch bearing placement I channeled it out slightly so that the ball bearings have room to move so you can roll this spinner around on a surface or with your finger or thumb.
Included is an STL for the Caps that I used
*Updates*
4.13.17 - Added 7 Bearing Mini Spinner. This Spinner uses 3/8 Inch Ball Bearings and was suggested and tested by *jmartellotta*
Enjoy!
This uses a 22mm bearing and 4, 1/2 inch steel ball bearings.
For the 1/2 inch bearing placement I channeled it out slightly so that the ball bearings have room to move so you can roll this spinner around on a surface or with your finger or thumb.
Included is an STL for the Caps that I used
*Updates*
4.13.17 - Added 7 Bearing Mini Spinner. This Spinner uses 3/8 Inch Ball Bearings and was suggested and tested by *jmartellotta*
Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!