Fix It Stick Holder

This is a container to hold the FixIt Stick and a set of bits used for gunsmithing.I recently bought the tool and the pin punch set they sell, but did not have anything to properly store them in.This holder consists of a tray that holds the main tool and is designed around the pin punch set, any other set of 6 bits should fit as well (assuming). A carrier box for holding the insert tray to keep it from spilling, and a button to assist with removal of the insert tray.The box is designed with a button mechanism on one end to push the tray out. The tray is 160mm x 78mm x 20mm, arguably anything that is the same dimensions should fit.The button is designed to be dropped into the box during the printing process, using the standard 0.4mm that came with my K2 Plus and a 0.2mm layer height, this resulted in a pause needing to be placed at the start of layer 55.Additionally the tray is designed for a deeper hole under the bits to allow you to stand the bits up right when working with them, and