Fixed Torque Wrench - super low torque

**This is a Fixed Torque Wrench remix with either 0.1Nm or 0.2Nm.**

I needed a torque wrench to assemble my new Phaetus Rapido 2 hotend and the instructions mention that a torque of only 0.1Nm should be used. So I recreated the awesome design by A_R_B and started experimenting.
The result was two rotors which can reliably trigger at either 0.2Nm or 0.1Nm (0.115 to be precise, but close enough for me...). They have only 6 instead of 12 fins, which are each also much thinner and shorter that the originals, but everything is still printable with a standard 0.4mm nozzle. **I recommend printing them in PETG to get the expected torque!**

These rotors fit the cases made by A_R_B, so please go ahead an download them from there.

For both torque settings there is also a special version where a 1.5mm hex key can be inserted, in case standard bits are too bulky to reach the screws.