Slicer Discord
Fizzy Rocket A-S Boat – 3D-Druckmodell von Thingiverse Thingiverse

Fizzy Rocket A-S Boat

2 Downloads
3 Likes
0 Makes
Zum Modell
If you put an Alka-Seltzer in a half-full film canister and seal it, the pressure of the releasing gas will make the lid pop off after ten second or so (KEEP YOUR FACE / EYES AWAY FROM THE LINE OF FIRE). If you turn it over on the ground, the whole canister will launch up. The trouble is that the second you put the tablet in, it begins to dissolve. I designed this little boat to float the tablet in the water, keeping it dry and giving you time to get the lid on. Turn it over on the ground, get back, and it will fly upwards.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen