Thingiverse
flair 58 controller holder
door Plastikflasche01
4
Downloads
4
Likes
0
Makes
Hello,
i designed a holder for my flair 58 heat controller. I wanted a clean look and i want to see if its done with preheating (blinking).
I printed both with support.
You need a M4-Screw to mount both pieces together. To mount it to the flair remove the lower screw at the side and screw it back on with the arm. Make it really tight. Otherwise the big horizontal ring where the brew head is mounted on will get a little loose.
I added washers and a spring-lock washer to connect both pieces. The lock washer is for keeping it tight when i adjust the angle of the controller. You can screw in the screw in the filament or drill a wider hole to place a threaded insert (i did that).
I also cut an old bike-tube to protect the varnish of the flair (it can be seen in one of the pictures). You could use any kind of flat rubber.
I hope someone can use this too.
i designed a holder for my flair 58 heat controller. I wanted a clean look and i want to see if its done with preheating (blinking).
I printed both with support.
You need a M4-Screw to mount both pieces together. To mount it to the flair remove the lower screw at the side and screw it back on with the arm. Make it really tight. Otherwise the big horizontal ring where the brew head is mounted on will get a little loose.
I added washers and a spring-lock washer to connect both pieces. The lock washer is for keeping it tight when i adjust the angle of the controller. You can screw in the screw in the filament or drill a wider hole to place a threaded insert (i did that).
I also cut an old bike-tube to protect the varnish of the flair (it can be seen in one of the pictures). You could use any kind of flat rubber.
I hope someone can use this too.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
