Flame - Large for Seeds

6/19/2026

Flame - Large - For Seeds:

This is my first attempt at making a flame. The purpose was to make a "fireball" for the dragon prop. However, this prop can also be turned 90 deg and look like a flame!
It is made for the smaller three wire white epoxy seeds. I recommend 4" spacing to avoid splices. I did measure and the farthest distance shouldn't be more than 3.5".
If you have "larger" seeds, you might still be able to use this prop! Just have the pixels face off the back of the prop. There has been limited testing for this, but I believe it will work!

It is composed of 48 separate pieces. (there are 2 test pieces used to test print and don't attach to the flame).
Most pieces are 6mm thick with a 2mm thick raised edge that is 10mm high. I believe this will be plenty strong and use less material than my previous attempt
using 10mm thickness through out.

Its approximate size is 836mm wide x 1259mm high (33.5in x 50.3in).
It holds 377 seed pixels.


Printer:
All the parts