Thingiverse
Flame - Small for Seeds
door Greenfieldaddy
0
Downloads
0
Likes
0
Makes
7/9/2026
Flame - Small - For Seeds:
More flames! The purpose was to make a "fireball" for the dragon prop. However, this prop can also be turned 90 deg and look like a flame!
It is made for the smaller three wire white epoxy seeds. I recommend 4" spacing to avoid splices. I did measure and the farthest distance shouldn't be more than 3.5".
If you have "larger" seeds, you might still be able to use this prop! Just have the pixels face off the back of the prop. There has been limited testing for this, but I believe it will work!
It is composed of 34 separate pieces. (there are 2 test pieces used to test print and don't attach to the flame).
Pieces are 6mm thick with a 2mm thick raised edge that is 10mm high.
Its approximate size is 600mm x 980mm (24in x 39in).
It holds 283 seed pixels.
Printer:
All the parts should be able to be printed on a minimum bed size of 220x220mm.
Assembly:
Please use the two Assembly pictures to see how to put it together. The picture with "Assem
Flame - Small - For Seeds:
More flames! The purpose was to make a "fireball" for the dragon prop. However, this prop can also be turned 90 deg and look like a flame!
It is made for the smaller three wire white epoxy seeds. I recommend 4" spacing to avoid splices. I did measure and the farthest distance shouldn't be more than 3.5".
If you have "larger" seeds, you might still be able to use this prop! Just have the pixels face off the back of the prop. There has been limited testing for this, but I believe it will work!
It is composed of 34 separate pieces. (there are 2 test pieces used to test print and don't attach to the flame).
Pieces are 6mm thick with a 2mm thick raised edge that is 10mm high.
Its approximate size is 600mm x 980mm (24in x 39in).
It holds 283 seed pixels.
Printer:
All the parts should be able to be printed on a minimum bed size of 220x220mm.
Assembly:
Please use the two Assembly pictures to see how to put it together. The picture with "Assem
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
