Flaming Torch

"Flaming torch" designed for my daughters project. This has been designed to fit a 3mm led and it is being fitted inside a cave for the project. You can upsize it for a 5mm led or even a 10mm led if you wish. I printed it at .2mm layer height and it looks fantastic. Print the "spike" separate and then insert the curved end into the hole at the bottom of the torch and glue with super glue. run two fine wires through the holes in the torch and trim the led legs down fairly short and then solder to the two wires. I suggest you then hot glue the led in place. You may choose to scrunch up some yellow cellophane to try and get a more flame look. Good luck. Let me know how you get on.
Print the spike and the torch base perpendicular to the bed of the printer. Use plenty of Brim and you won't have a problem.