Slicer Discord
FLAPJACK – Modello 3D stampabile da Thingiverse Thingiverse

FLAPJACK

105 Download
63 Likes
1 Makes
Vai al Modello
This is a remix of a remix. Original post is a 150g antweight called Blockhead by earthwormjim - https://www.thingiverse.com/thing:2812197

I remixed it to a 1 pound US ant and was super happy with it as a design.
https://www.thingiverse.com/thing:3111090

This a V2 of my design, improving on what I saw in its first 5 fights of the V1 at mass destruction at maker fair NYC.

- my original 180 mah battery conked out after about 90 seconds of full thrust (because math is hard). increasing to 450 mah.
- the v1 flat beater bar accomplished only a few good hits. This is a larger bar and now has an angled attack.
- added a ramp under the bar to get some lift on the opponent to set up a better hit.
- N20 motors can and do easily fail. this design allows N20 to be swapped out much more easily by dropping out of the bottom surface..
- on/off switch changed to be accessed on top side.


BOM of Electronics I crammed in there:
Esc = DasMikro Duel (http://tinyurl.com/ybvkxqxj)
R
Fonte
Thingiverse
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione