Flash Forge Creator Pro X-Carriage

Hello Thingiverse,

I was having issues with my X-Carriage binding because the stock design is too large, causing the bearings to fail prematurely.

I redesigned the carriage In a way that allows for a slight amount of adjustment on the bearing spacing, this way they are all positioned perfectly and my carriage no longer binds.

I replaced all the bearings in the X & Y axis with these bearings from MISUMI (LMU-N8), Note that they are longer than the stock bearings but they will fit fine in the stock y-axis carriages. These run about 5$ a piece.

This also requires (6) M2 - 12 mm lg. Socket head cap screws, & (6) M2 Nuts.

DO NOT BUY THE CHEAPER BEARINGS ON AMAZON, I tried those first and they were such poor quality they were unusable.

I hope this model helps out other FFCP users having the same issue, Happy Printing!