Flash Forge Finder 3 Enclosure

Created these parts to attach to my finder 3 and am posting due to interest on the Flashforge face book group
I printed them with PLA pro but would recomend using someone with a little more heat resistance. It Has not sagged or caused an issue as yet but the hood does really capture the heat.

if I was to do it again I would redesign so all parts to join with a lap joint . in this instance they're just but joints.
I super glued the parts in place using the joining straps and once the frame was assembled I went around the seams with a 3d print pen, welding the joins shut . this works but does require some skill.

anyway I've designed the top frame to be assembled with 2mm plexiglass windows .which had to be cut to size and bonded in .

I did intend to extend the back over hang down to cover the filament roll but the chamber gets hot enough to print large ABS and ASA models with out.

the front sill, coupled with long/ short stop and top grove, I mounted to the machine wit