MakerWorld
Hueforge & Lithophane
Ver Modelo
Flash
6
Descargas
5
Likes
5
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 90x160mm in sizeYou may print at higher layer heights below the Min Depth of 0.88mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mm Filaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Red Transmission Distance: 3.9 PLA BambuLab Basic Orange Transmission Distance: 6.9 PLA BambuLab Basic Yellow Transmission Distance: 5.9This print uses 4 unique filaments Swap Instructions: Start with Black At layer #13 (1.12mm) swap to Red At layer #17 (1.44mm) swap to Orange At layer #24 (2mm) swap to Yellow for the rest.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
