Flashforge AD5X Adjustable tilt mount

Credit to @brentv_3654830 My AD5X towers above me at my desk, because the default orientation points up, its impossible to see the screen when sitting, and even standing is at an angle away from me. This mount allows me to position it slightly down so I can see the screen both while seated and standing. Note 1: The threads are reversed! Note 2) The screw holes were slightly too narrow on my first print to align with the holes on the back of the screen. I just drilled one out slightly. I edited the STL file to move them but they might need further tweaking. I don't plan to print it again so YMMV This uses the existing hole on the AD5X frame and the two unused screw holes on the back of the screen. I don't know the threads on the screen. I just used whatever screws I had in a bin. Make sure its tight, and don't point it down too much, It might be possible to hit the build plate if you face it down all the way. EDIT 10/11/25: Added a modified AD5X sceen mount that should allow the tilt mo