FlashForge AD5X Front LED Strip Brackets

The front orange brackets are my original design. I like them better so I don't see the glare from side LEDs.
Ignore any floating regions message. No trees needed.
The base is thin in order to fit beneath long enclosure pillars, (A3,D3, if you have an enclosure.)
The two largest brackets are secured to the printer frame with the screws from the frame. (See Arrow)
I used the black 5m brackets as washers to fit in the round holes in the LED bar and for 2 M3*6 screws when I screwed the LED bar to my front brackets.
The four red brackets are used to secure the LED wires to the frame on the filament spool side.

The black 5mm FlashForge Brackets are by:
and1re
@and1re_1596116 on Printables

The 4 AD5X LED Strip Mounts are by:
cyberdorkbl33
@cyberdork33 on Printables