Thingiverse
Flashforge Adventurer 4 calibration test
door PrintahNoob
6
Downloads
4
Likes
0
Makes
This print is a single layer test print designed to surface levelling issues on your Flashforge Adventurer 4. The design is 220mm x 200mm to fit the entire printable area of the ADV4.
The ADV4 has a 9-point bed levelling system that does not provide levelling values for the spaces in between. The 9 points are not sufficient to get a true picture of where your printer is too close or too far away from the nozzle. The diamond shapes represent a travel of 50% from each measuring point along with a number of mid-points in the center of the bed.
Use the print to visual problem areas. Avoid scaling the STIL file because it will alter the 02.mm layer height.
The ADV4 has a 9-point bed levelling system that does not provide levelling values for the spaces in between. The 9 points are not sufficient to get a true picture of where your printer is too close or too far away from the nozzle. The diamond shapes represent a travel of 50% from each measuring point along with a number of mid-points in the center of the bed.
Use the print to visual problem areas. Avoid scaling the STIL file because it will alter the 02.mm layer height.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
