Flashforge Creative Pro Filament set

This is a set of things that should help you to handle filament better on a 3d printer Flashforge creative pro I bought in 2017.

Spools with different inner diameters can be fixed with the filament holder at the back side of the printer.

The bridge for the filament alignment helps to prevent the filament from knotting during printing.

This is a remake off a lot of things

Spool-Holder: (Remix of https://www.thingiverse.com/thing:1001925 and https://www.thingiverse.com/thing:193647): The spool holder is a huge screw with a conical nut.

The "Filament Alignment" is a remix of https://www.thingiverse.com/thing:2353402. The tubes are slightly wider than in the original design and taper at the bottom.

Printer parameters:
raft: Yes
Support: yes only for Spool Holder
Filling: 25%