Slicer Discord
Flashforge creator 50mm fan mount – 3D-printbaar model van Thingiverse Thingiverse

Flashforge creator 50mm fan mount

door davinci85
279 Downloads
164 Likes
5 Makes
Model downloaden
*Update 1/30/2016
I added another version of fan-mount with flat bottom.
File name - fan-mount-7b2

*Update 9/26/2014
I added permanent support under the part where the fan rests. This "should" give you cleaner finish, but I have not tested yet. Let me know what happens.

*for the updated version, download "fan-mount-7b"

Finally!
After 6 times of failure, it is finished.
I found this fan from a trashed computer and I just had to figure out the way to use it, instead of buying a new fan.
This fan mount doesn't require any screws. Just snap on.
However it is only for 50mm fan.
...and I mounted it, but I have not tested yet, because I am not good at electrical wiring. so, if you want to try this, do it at your own risk.
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie