FlashForge Creator Cable Management and fliament guide

Created a way to secure the filament tubes and cable management to the print head. The rear bracket moves the tubes more to the center of the filament spools and eliminates the clamps that never really secure the tubes. Also eliminates the cheap cable cover that just flops all over. The tubes are also inserted in the back holder about 4cm and at the print head 1.5cm to eliminate the tubes from coming off and breaking the filament. I used 21 of the cable cups/chain, and recommend inserting a length of spring wire to improve the stability of the chain.
Print the chain with the open end down for best results no support needed. The back bracket print up right with supports. I used PLA for everything except the print head bracket. I used ABS for the print head bracket to improve heat resistance and printed it right side up.