Thingiverse
Flashforge Creator Pro Bondtech Compatible Fan Mount Plate
door Corpulent
11
Downloads
9
Likes
0
Makes
This is a mount plate for the Flashforge Creator Pro cooling fan that has been modeled off the original, but with clearance for the Bondtech extruder upgrade (EXT-MBK-5).
Requires three M3 nuts with a point to point diameter of 6.5 mm (6 mm flat to flat). Use a small piece of filament to create the alignment peg (the model contains a hole for it), which should stick out about 2 mm.
Print in ABS.
Requires three M3 nuts with a point to point diameter of 6.5 mm (6 mm flat to flat). Use a small piece of filament to create the alignment peg (the model contains a hole for it), which should stick out about 2 mm.
Print in ABS.
Corpulent publiceert ook op
17 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
