Thingiverse
FlashForge Creator Pro - Cable Clip
von krazy_elmo
128
Downloads
65
Likes
4
Makes
A simple support clip for the extruder feed tubes on later FFCP units.
The common clip already floating around on the net didn't suit my new unit. Because the cable/feed tube lengths are very similar, the large offset designed into the old clip doesn't fit well. Also the power cable tube is smaller.
I used 4 clips (see pics) and it works great without fouling on the perspex cover.
Hope it helps you and yours!
Cheers
The common clip already floating around on the net didn't suit my new unit. Because the cable/feed tube lengths are very similar, the large offset designed into the old clip doesn't fit well. Also the power cable tube is smaller.
I used 4 clips (see pics) and it works great without fouling on the perspex cover.
Hope it helps you and yours!
Cheers
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!