Thingiverse
FlashForge Creator pro glass bed clamp
door silvxm
65
Downloads
31
Likes
2
Makes
Here are some bed clamps for the glass on the old flashforge creator pro.
These are much better than the binder clips because it allows you to print over the entire bed without worrying about crashing into ANYTHING!
The fit overtop the existing nuts holding the heated plate. All that needs doing is adding an extra m3 nut AND washer (important) on the underside.
enjoy!
These are much better than the binder clips because it allows you to print over the entire bed without worrying about crashing into ANYTHING!
The fit overtop the existing nuts holding the heated plate. All that needs doing is adding an extra m3 nut AND washer (important) on the underside.
enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!