Flashforge Creator Pro replacement Carriage for E3D v6

UPDATES
09/10/21 - Added a mounting for a 5015 style blower fan.


This is a remix of both https://www.thingiverse.com/thing:1350343 & https://www.thingiverse.com/thing:3547317

I remade the X carriage to have only three bearing mounts, this should help stop binding in the long term.

This design utilises the original 30mm fan for the hot end cooling.
It also leaves enough room for a 4020 as the part cooling fan.

The fan duct fits into the clamp block separately, this makes it easier to print, and design/test.

I have left the screw holes open to either use plastic screws, or brass inserts, you may need to drill some of the holes out to fit brass inserts if that's the case.

I have my hot end wires coming out the back, and have rotated my stepper motor 90 degrees so the wires exit out the same side, this just makes for a cleaner install. though the wires are pretty secure when bundled together, I am working on a more secure attachment for them so they are not flexing a