FLashForge Creator Pro X Fan + Cable Chain

This is based on csatti's original cable chain and fan setup for the WanHao Duplicator. I wanted to put this on mine and quickly found out that it wasn't going to work. It may work just fine for those creator folks, but the pro will be a no go. The major problem, the stepper for Y motion is set lower than in the creator and the chain keeps the Y axis from homing (bummer).

So, I fired up sketchup and changed it around and presto works great. I then ran into another obstacle. I wanted the wires to be nicely bundled and make it look nice. I had also read that folks were complaining that either their Y stepper bracket was broken or weak so I came up with this contraption. And it works really well. There is a second revised file that inclues a half hole out the other side as well to allow wires to pass freely to the wire loom and down the frame. On mine I didn't put it in and saw that It should be there so I will be uploading both. It wont hurt, its just for looks and wont make the cab