Flashforge Creator X Z-axis switch mount.

Updated to 5.5mm 7/11/14. 1/4" glass needed a little bit more space. Should still be able to use it for 3/16" glass.
This is switch mount for the Creator X, but it might fit on the Creator Pro. Recently I installed the Creator Pro platform in the Creator X. This means the old style clip on spacers wont work anymore. This piece will allow you to remount your switch 5.5mm lower for when you are using 3/16" glass or 1/4" glass on top of the aluminum build plate.
There are 4 little plastic spacers behind the switch, these aren't needed anymore. The spacing is built in. Just mount the switch right on top of of the two posts. You will need a couple 3mm x 12mm flat head screws to mount this to the posts. Use a little blue thread lock on the screws that go into the posts to help prevent them from coming loose.