Thingiverse
Flashforge extruder cooling duct
von repurposer
17
Downloads
14
Likes
1
Makes
remixed from http://www.thingiverse.com/thing:327387 all that was done was some parts were made longer to fit my specs. I did have to shave a little off the tray to make it sit nice and flush to everything
EDIT: To clarify: When I fitted this part to my extruder, I did have to cut two or three layers off of the tray that fits under the fan so that the shroud could contact the fan. It may be that trezhunter's part would have fit as-is if I had tried that, ymmv
EDIT: To clarify: When I fitted this part to my extruder, I did have to cut two or three layers off of the tray that fits under the fan so that the shroud could contact the fan. It may be that trezhunter's part would have fit as-is if I had tried that, ymmv
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!