FlashForge Filament Dry Box

Still a work in progress.

The Dry boxes fit the Creator Pro frame perfectly. I have this dry box sitting on top of an overturned box.

***1/13/2021 Update***
I'm not a fan of the single bar design any more. Changing out one roll can be cumbersome so I'm probably going to switch to a roller bearing, pedestal for the rolls to sit on instead.

File List:

Hygrometer Prob Wire Clip.stl
Holds the hygrometer probe wire out of the way of moving parts, clips to the rear carriage of the extruder pulleys.

Hygrometer Probe Clip.stl
Used to hold the probe of the hygrometer inside the printer.

Tubing bulkhead adapter 6MM smooth to 5MM thread.stl
Adapter for the extruder PTFE tubes to connect to the exterior push to connect fittings. I recommend sliding the PTFE into these, then screw the PTC fittings onto them.

Rod Holder 1.stl
Rod Holder 2.stl
Holds the 3/4" rod. Need two. One allows you to lift up on one end of the rod in order to slide the spools off.

T