FlashForge Finder - external filament adaptor

Something i cooked up to run external rolls of filament on my Finder.

Two parts:

1) a clip for the back, clips to the original filament holder, which runs the filament through.
2) an adaptor for the head which holds onto the original filament tube a bit better (stops it constantly falling out)

Both parts allow you to use the original "feed tube" while using an external roll of filament.

Photos show an earlier prototype... the one here is solid (stronger) and a bit longer so the filament doesn't run up the back of the printer as much.

Hope you enjoy it as much as i enjoyed designing it!

The roll holders also available in my things to complete the set up.