Thingiverse
FlashForge Finder tool holder
von Flamingpumpkin
7
Downloads
4
Likes
0
Makes
This is a tool caddy for the Flashforge Finder.
I printed with the top face down with 2mm zigzag support for the tray area.
feel free to improve upon this design as i have included the sketchup file.
Mine warped a fair bit in the corner but actually looked nice so I just ran with it
you may want to increase your temp for the 1st 2 layers to 230C to get better adhesion.
there is a radius on everything so there shouldn't he any elephants foot issue.
I printed with the top face down with 2mm zigzag support for the tray area.
feel free to improve upon this design as i have included the sketchup file.
Mine warped a fair bit in the corner but actually looked nice so I just ran with it
you may want to increase your temp for the 1st 2 layers to 230C to get better adhesion.
there is a radius on everything so there shouldn't he any elephants foot issue.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!